Knowledge Base:  
You are here: MSDS > Fusion Gun Questions
HOT WEATHER problems with spray foam.
Last Updated: 06/07/2012
This time of year, we get numerous calls with issues on guns locking up, crossing over and guns spraying for a few seconds before it just stops spraying. As the weather gets hotter, the gun cross-overs will increase. REDUCE YOUR HOSE HEAT.

Running your hose heaters at 130 and having the hose run across 200' of roof deck on a hot day makes the chemical too hot. In the southern regions, most roof decks are over 130 during the afternoon.

If you start to spray and only work for a minute or two before the gun locks up - its not the seals, its your temperatures. We have done roof jobs with the heaters on 90 to spray. You will also notice when you dis-assemble the gun that it is clean compared to what a normal cross over looks like inside.

How to test your chemicals to see if they're too hot: Remove the manifold assembly from the gun. With the system pressure OFF and on JOG to circulate the fluid, open the "B" side shut off valve and pour 1/2oz into a paper cup. If the fluid begins to "Froth" into a foam (like a beer from an empty keg) - reduce the heat. You may need to recirculate the fluid to get all the hot chemical out of the hose and allow time for everything to cool down some. Set your heater at 100 - its much easier to heat up, than to cool down. If the chemical is not hot enough, the reaction time will be slow or the foam will be "spongee". Increase the temperature another 5. Chances are, if you're spraying on a steel building or a roof deck, the surface temperature you're spraying on is 110-150 and that will cause the foam to react anyway. 


Was this article helpful?

Comments:
 

Related Articles
 > No Purge Air
 > Chambers resurfaced on sandpaper
 > : My gun has a very slow response when I pull the trigger. Its not as fast as it used to be.
 > My chamber broke on the lock tab (or piston were the chamber locks on)
 > No fan pattern when spraying, it's just a pee stream
 > O-Rings - Are your the same as Graco?
 > Boiling parts in antifreeze. Manufacturers love it when you do.
 > SPF Solvents: What to use for everyday cleaning.
 > My side cartridge broke.
 > Flushing the "A" Side hose. How many gallons of fluid do I need to flush it out?
 > What can I use to flush my "A" side hose?
 > Proper shut down of the gun at the end of the day