Knowledge Base:  
You are here: MSDS > Fusion Gun Questions
: My gun has a very slow response when I pull the trigger. Its not as fast as it used to be.
Last Updated: 06/06/2012

ANSWER: The problem is the muffler/Exhaust port on the bottom of the gun handle. On the bottom of the handle is a hex head bolt with a 1/8" hole in the center. That's the breather/filter - assembly # 22. Remove the part and your speed should be normal. I left mine out, but you can push a nail through the small screen. As foam and grease collect on the screen, the exhaust leaving is slowed down causing the shift force to work against itself. Many factory people will claim you have to have that to prevent foam from entering the gun handle. I say - If you have that much foam blowing in the air, you have far bigger issues to address.

Was this article helpful?


Related Articles
 > No Purge Air
 > Chambers resurfaced on sandpaper
 > My chamber broke on the lock tab (or piston were the chamber locks on)
 > HOT WEATHER problems with spray foam.
 > No fan pattern when spraying, it's just a pee stream
 > O-Rings - Are your the same as Graco?
 > Boiling parts in antifreeze. Manufacturers love it when you do.
 > SPF Solvents: What to use for everyday cleaning.
 > My side cartridge broke.
 > Flushing the "A" Side hose. How many gallons of fluid do I need to flush it out?
 > What can I use to flush my "A" side hose?
 > Proper shut down of the gun at the end of the day