IPM Transfer Stick Pumps to Replace Graco T1 and T2 Series Transfer Pumps
- High-Shear Blending: Specifically pitched to thoroughly re-integrate blowing agents that have settled, preventing the density fluctuations that ruin foam yield.
- Hardened Stainless Steel: Machined from high-grade stainless to resist the corrosive "B-side" resins that typically eat through standard steel or aluminum blades.
- Collapsible Precision: Designed to slip through a standard 2-inch drum bung and expand fully to 8 inches, ensuring a complete sweep of the drum bottom.
The IPM-Mixer Blade, 8", Stainless from SPF Depot is a critical upgrade for your spray foam equipment. If you’re running a Reactor E-30 and notice your Fusion AP gun is constantly clogging, the culprit is often poor agitation leading to "chunky" resin. Unlike flimsy Graco pump replacement parts, this SPF-made blade is reinforced at the hub to prevent snapping under high-viscosity loads. From our experience, if you're struggling with a pressure imbalance, check your drum mix first; a well-blended drum prevents particles from reaching your mix chambers and side seals. Whether you're refreshing your rig with a Graco pump repair kit or looking for superior spray foam supplies, this blade ensures your foam insulation equipment stays productive.
- Eliminate Off-Ratio Foam: Proper mixing ensures the chemical reaction is consistent from the top of the drum to the bottom.
- Reduce Gun Maintenance: Prevents unmixed solids from reaching your spray foam gun parts, extending the life of your chamber.
- Industrial Compatibility: Fits most standard 1/2" mixer shafts used in professional SPF rigs.
Shop Reactor Parts. Get Expert Help.
